|
Page 4 of 6
| 1. The first thing we do is open the radio up and make sure all the parts we need to use are working properly. |
|
| 2. Then we go ahead and take all the unneeded electronics out leaving the parts needed to just operate the new board. |
|
| 3. After the radio is gutted, we clean and paint the radio if needed. Then it's time to mount the board and start the wiring. |
|
| 4. Now that the radio is all wired and everything is secure. We go ahead and test it to make sure everything is working properly. |
|
| 5. Finally the radio is done. It now has AM/FM and 180 watts of power. The radio will sound so much better and as you noticed it still looks the same on the outside. |
|
|
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device
