|
Page 4 of 6 | 1. The first thing we do is open the radio up and make sure all the parts we need to use are working properly. | | | 2. Then we go ahead and take all the un needed electronics out leaving the parts needed to just operate the new board. | | | 3. After the radio is gutted we clean and paint the radio if needed. Then it's time to mount the board and start the wiring. | | | 4. Now that the radio is all wired and everything is secure. We go ahead and test it to make sure everything is working properly. | | | 5. Finally the radio is done. It now has AM/FM and 180 watts of power. The radio will sound so much better and as you noticed it still looks the same on the outside. | |
|
